Huai'an equipment displacement In order to ensure the safety of handling and loading operations, we should pay attention to the following matters during the operation:

1. The operation site shall be provided with unified command and clear and fixed command signal to prevent operation confusion and accidents. The handling personnel and machine operators at the operation site shall strictly observe labor discipline and obey the command. Non handling personnel are not allowed to stay at the operation site.

2. For various loading and unloading equipment, safety operation procedures must be formulated and operated by full-time personnel who have received operation training to prevent accidents.

3. Before loading, unloading and handling dangerous goods, it is necessary to strictly implement the operating procedures and relevant regulations, make preparations in advance, and carefully check the loading, unloading and handling tools and operating equipment. After the work is completed, the substances contaminated on the tools must be removed to prevent chemical reactions caused by conflicting substances. The tools for operating peroxide articles must be cleaned before use.

4. Determine the performance of lifting appliances

If the equipment is large, it is necessary to use lifting equipment with good performance, pay attention to the performance and quality of wire ropes, slings, etc., and ensure that the lifting equipment can pull the equipment;

5. Determine the stable placement of equipment

If the balance of the handling equipment is poor, first select a flat and solid site for security. It is better to add a load-bearing balance base to stabilize the equipment to prevent tilting and bumping. If the site is relatively soft, the compactness of the ground should be determined, or some base planks and planks should be added to ensure that the equipment chassis can be safely connected to the platform;

6. Carrying capacity of transport corridor

Handling of plant equipment Before relocation, the upper clearance of bridges and culverts on the driving route and the bearing capacity of roads and bridges shall be ascertained. When passing the bridge, the low-speed gear shall be used to drive slowly, and no steering or braking is allowed on the bridge deck. For bridges with insufficient bearing capacity, reinforcement measures must be formulated in advance;

7. Vulnerable area of protection equipment

If the equipment to be handled is a precision instrument, first of all, it is necessary to know which parts of the instrument are the most vulnerable, and special care must be taken. Generally, air cushion film, blanket and other shock absorption measures should be taken, and care should also be taken when handling with lifting equipment;