Huai'an Crane Leasing Company Xinyu Heavy Equipment reminds everyone that the following points should be avoided when renting large lifting equipment: the lifting points should be determined and the lifting lugs should be selected and installed when lifting equipment: if there are lifting lugs on the equipment body, the lifting lugs can be used if there are no lifting lugs on the equipment body. If there are no lifting lugs on the equipment body, the lifting lugs for installing equipment should be selected according to the requirements of on-site equipment lifting according to relevant specifications. Generally, the lifting lug shall be made of materials consistent with the body, and the material inspection shall be done well.

1. Overload is strictly prohibited.

2. When two lifting belts are working, hang the two lifting belts directly into the double hook. The lifting belt shall be hung at the symmetrical stress center of the double hook; When four lifting belts are used, every two lifting belts are directly hung into the double hooks. Note that the lifting belts in the hooks cannot overlap and squeeze each other. The lifting belts should be symmetrical to the force center of the hooks.

3. When using the lifting belt, hang the lifting belt directly into the force center of the hook instead of the hook tip.

4. During the lifting operation, the lifting belt shall not be crossed, twisted, knotted or screwed, and shall be connected with correct special connectors for the lifting belt.

5. When encountering goods with sharp corners and edges, the sling must be protected by sheath, angle protection and other methods to extend the service life of the sling. The use of slings on rough surfaces is strictly prohibited. To prevent the sling from being cut off by corners and scratched by rough surfaces.

6. Double turn chokes are more secure.

7. When using the lifting belt, the flat lifting belt cannot bear evenly in the width direction due to the bending part of the hook, which is affected by the inner diameter of the hook. If the diameter of the hook is too small and the combination with the webbing eye is not sufficient, the correct connector shall be used for connection.

8. The correct lifting method shall be adopted when lifting pipe objects. If the lifting angle is too high, there will be potential safety hazards.

9. Do not press objects on the lifting belt, which may cause damage to the lifting belt. Do not try to pull the lifting belt out from below, which may cause danger. Use objects to pad up and leave enough space for the lifting belt to be taken out smoothly.

10. The lifting belt shall not be dragged on the ground or rough surface.

11. After use, the sling shall be suspended for storage.