The crane is prone to some problems during use, so daily maintenance is essential Huai'an crane rental The manufacturer has checked the contents of daily maintenance of cranes for you and summarized several points:

1. All transmission parts of the crane shall be regularly filled with lubricating grease.

2. Once the crane is found to have a weld off position, it shall be repaired in time.

3. The screws at the connection of the crane body shall be checked regularly, and any looseness found shall be handled in time.

4. In case of paint dropping, paint shall be repaired in time to prevent excessive corrosion and affecting the service life of the crane.

5. Regularly check the wire rope of the small crane, and replace it in time if serious wear is found.

In addition, there are many frost, fog, rain and snow, and low temperature in winter, which add many difficulties for drivers to drive, and also bring many adverse factors to driving safety. Let's Huai'an Crane Rental The manufacturer will share it with you again.

1. Drivers must attach great importance to driving safety in special winter weather and improve their awareness of safe driving; At departure; Concentrate on controlling the speed, standardize driving, and deal with emergencies such as skidding, sideslip, deviation, pedestrian and non motor vehicle crossing in a predictable manner when starting, stopping, turning, lane changing, meeting, etc; It is forbidden to start on the slope in ice and snow weather.

2. Before driving out, the driver must carefully check the safety equipment on the vehicle: steering, braking, lights, instruments, speakers, wipers, etc. must be complete and effective;. When driving in fog, clean the windshield and light glass, turn on the anti fog lamps, low beam lamps, front and rear small lamps, side marker lamps and tail lamps as required, make full use of the light to improve visibility, and clearly see the road ahead, vehicles and pedestrians.

3. Drive steadily. The roads are slippery after snow in winter. When driving, pay attention to the steady speed and operation, such as rapid acceleration, sudden braking, and sudden steering. Accelerate steadily and drive at medium and low speeds.

4. Refueling slowly. When starting and accelerating, refueling should be light and slow to prevent tire skidding and sideslip. Because you refuel too fast, the driving force of the vehicle is greater than the adhesion of the road, resulting in the idling of the driving wheels and the lateral deviation of the vehicle. Therefore, the accelerator must be well controlled to make the driving force less than the road adhesion, so as to avoid or reduce the occurrence of skidding and sideslip.

5. Slow down. When decelerating, make full use of the resistance of the engine to decelerate, that is, quickly release the accelerator without shifting out of gear or stepping on the clutch, so as to immediately reduce the engine speed, force the driving wheel speed to reduce, thus decelerating the vehicle. If you need to use the brakes to stop, you should also use the engine brakes to slow down, and then gently apply the brakes. It is strictly prohibited to apply emergency braking on ice and snow roads to avoid vehicle sideslip. Vehicles without ABS shall pay special attention to prevent sideslip. When parking, try to choose a space free of ice and snow, tighten the hand brake and shift gears, and block the wheels if necessary.

6. Turn slowly. When turning, be sure to slow down first, increase the turning radius appropriately, and turn the steering wheel slowly. The operation of the steering wheel should be smooth and gentle, otherwise side slip will also occur, causing the rear of the vehicle to swing outward (tail flick). The reason for sideslip when turning is that the steering wheel deflects laterally due to oversteer, resulting in a sudden increase in resistance in the front of the vehicle, and the rear of the vehicle throws outward under the inertial action. If sideslip occurs, it can be relieved by proper wheel return.

That's it Huai'an equipment displacement The manufacturer's answer to this question, if you have other questions and needs, please contact us.