There are many lifting methods. For safety reasons, Huai'an Xinyu Heavy Equipment Co., Ltd. tells you some things to avoid when lifting. When lifting equipment, the lifting points shall be determined and the lifting lugs shall be selected and installed: if there are lifting lugs on the equipment body, the lifting lugs can be used. If there are no lifting lugs on the equipment body, the lifting lugs for installing equipment shall be selected according to the requirements of on-site equipment lifting according to relevant specifications. Generally, the lifting lug shall be made of materials consistent with the body, and the material inspection shall be done well.

The following points should be avoided for the lifting belt of Huai'an large hoisting equipment:

1. Overload is strictly prohibited.

2. When two lifting belts are working, hang the two lifting belts directly into the double hook. The lifting belt shall be hung at the symmetrical stress center of the double hook; When four lifting belts are used, every two lifting belts are directly hung into the double hooks. Note that the lifting belts in the hooks cannot overlap and squeeze each other. The lifting belts should be symmetrical to the force center of the hooks.

3. When using the lifting belt, hang the lifting belt directly into the force center of the hook instead of the hook tip.

4. During the lifting operation, the lifting belt shall not be crossed, twisted, knotted or screwed, and shall be connected with correct special connectors for the lifting belt.

5. When encountering goods with sharp corners and edges, the sling must be protected by sheath, angle protection and other methods to extend the service life of the sling. The use of slings on rough surfaces is strictly prohibited. To prevent the sling from being cut off by corners and scratched by rough surfaces.

6. Double turn chokes are more secure.

7. When using the lifting belt, the flat lifting belt cannot bear evenly in the width direction due to the bending part of the hook, which is affected by the inner diameter of the hook. If the diameter of the hook is too small and the combination with the webbing eye is not sufficient, the correct connector shall be used for connection.

8. The correct lifting method shall be adopted when lifting pipe objects. If the lifting angle is too high, there will be potential safety hazards.

9. Do not press objects on the lifting belt, which may cause damage to the lifting belt. Do not try to pull the lifting belt out from below, which may cause danger. Use objects to pad up and leave enough space for the lifting belt to be taken out smoothly.

10. The lifting belt shall not be dragged on the ground or rough surface.

11. After use, the sling shall be suspended for storage.

The sliding delivery method of the winch towing platoon for large hoisting in Huai'an: the sliding delivery method of the winch towing platoon is generally used in the hoisting process. This method needs to design a traction winch in front of a steel trailer. This method requires that the equipment taxiing road should not only be compacted but also leveled.

During the operation, the overall coordination and operation coordination requirements of the lifting shall be consistent to ensure the continuity and stability of the lifting process. Reinforcement measures for the lifting equipment skirt: if the equipment is heavy and bulky, the force on the tail skirt will be concentrated when lifting. In order to prevent deformation of skirt during hoisting, reinforcement measures must be taken at the bottom of skirt to increase triangular support or cross support to reduce deformation of skirt during hoisting so as not to affect the positioning speed of equipment.